New Updated Cisco CCNA Wireless 640-722 Real Exam Download 1-10

Ensurepass

QUESTION 1

The IEEE 802.11n standard provides 40-MHz channels, improved MAC efficiency, and MIMO.

Which three elements define the 802.11n implementation of MIMO? (Choose three.)

 

A.      channel bonding

B.      dynamic frequency selection

C.      maximal ratio combining

D.      packet aggregation

E.       spatial multiplexing

F.       transmit beam forming

 

Correct Answer: CEF

 

 

QUESTION 2

Which two statements about WiMAX technology are true? (Choose two.)

 

A.      WiMAX is defined by 802.11i.

B.      Typically, fixed WiMAX networks have a higher-gain directional antenna installed near the

client.

C.      WiMAX is capable of working as a long-range system over several miles.

D.      WiMAX works only for licensed frequencies.

 

Correct Answer: BC

 

 

QUESTION 3

Which governing body analyzes the applications and environments in which wireless networks

are used?

 

A.      EIRP

B.      ETSI

C.      FCC

D.      IEEE

E.       WiFi Alliance

 

Correct Answer: D

 

 

QUESTION 4

Which description best describes upfade in a multipath environment?

 

A.      In this situation, multiple signal paths are not sent at exactly the same time. The receiver

receives a positive crest on the primary signal and a negative crest on the secondary signal.

B.      In this situation, the multiple signal paths are distorted and difficult to understand.

C.      In this situation, the multiple signal paths are weaker than they should be because the

signals are out of phase with each other.

D.      In this situation, the signal is stronger than it should be because multiple signal paths are

received twice at exactly the same time, which results in the multiple signals being in-phase.

 

Correct Answer: D

 

 

QUESTION 5

A controller is connected to a Cisco Catalyst switch. The switch port configuration looks like this:

 

interface GigabitEthernet 1/0/10

switchport

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 1,20,30,50

switchport trunk native vlan 20

switchport mode trunk

 

Which controller CLI command assigns its management interface to the native VLAN interface of

the Cisco Catalyst switch?

 

A.      config interface vlan management 0

B.      config interface vlan management 1

C.      config interface vlan management 20

D.      config interface vlan management 30

E.       config interface vlan management 50

 

Correct Answer: A

 

 

QUESTION 6

Which statement about an infrastructure basic service set is true according to IEEE 802.11

specifications?

 

A.      The set also is called an ad hoc network.

B.      The BSSID is generated from the first wireless client that starts up in the IBSS.

C.      The set enables the use of ESS.

D.      No signals are relayed from one client to another client.

 

Correct Answer: C

 

 

QUESTION 7

Which two factors must be considered when evaluating an RF interferer for severity?

(Choose two.)

 

A.      distance from the AP

B.      dBm

C.      the type of security crack being used

D.      duty cycle

E.       number of interfering IP stations in the cell

F.       duplicate SSID

 

Correct Answer: BD

 

 

QUESTION 8

Which two items are needed to discover the IP address of a new Cisco Aironet 1260 autonomous

AP that just finished booting? (Choose two.)

 

A.      username = “cisco” and password = “cisco”

B.      username = “Admin” and password = “Cisco”

C.      username=Cisco and password=Cisco

D.      show int vlan1

E.       show int bvi1

F.       show int gigabitethernet0

G.      show int radio0-802.11n

H.      show int radio1-802.11n

 

Correct Answer: CE

 

 

QUESTION 9

Which statement correctly describes the procedure for a lightweight AP to successfully establish

a connection to a controller?

 

A.      The AP authenticates the received Cisco WLC certificate as valid. The AP then sends its

certificate to the controller.

B.      The AP sends its certificate to the controller. The AP then authenticates the received Cisco

WLC certificate as valid.

C.      The AP sends its certificate to the RADIUS server. The AP then authenticates the controller

certificate as valid.

D.      The AP sends its certificate to the RADIUS server. The AP then authenticates the RADIUS

certificate as valid.

E.       The AP authenticates the received RADIUS server certificate as valid. The AP then sends its

certificate to the RADIUS server.

F.       The AP authenticates the received RADIUS server certificate as valid. The AP then sends its

certificate to the controller.

 

Correct Answer: B

 

 

QUESTION 10

Which two statements about the requirements to configure inter-controller roaming are true?

(Choose two.)

 

A.        The same mobility domain names are configured across controllers.

B.        The same RF group names are configured across controllers.

C.        The same controller hardware version is configured across controllers.

D.        The same AP manager interface is configured across controllers.

E.         The same virtual interface is configured across controllers.

F.         The same controller software version is configured across controllers.

 

Correct Answer: AE

 

Download Latest Complete Collection of CCNA Wireless 640-722 Real Q&As ,help you to pass exam 100%.

Ensurepass Cisco Certifications Exam Questions and Answers
Ensurepass CCNA Wireless Exams Questions and Answers

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.