QUESTION 71
Refer to the exhibit. A Cisco ASA in transparent firewall mode generates the log messages seen in the exhibit. What should be configured on the Cisco ASA to allow the denied traffic?
A. extended ACL on the outside and inside interface to permit the multicast traffic
B. EtherType ACL on the outside and inside interface to permit the multicast traffic
C. stateful packet inspection
D. static ARP mapping
E. static MAC address mapping
Correct Answer: A
QUESTION 72
With active/standby failover, what happens if the standby Cisco ASA does not receive three consecutive hello messages from the active Cisco ASA o
n the LAN failover interface?
A. The standby ASA immediately becomes the active ASA.
B. The standby ASA eventually becomes the active ASA after three times the hold-down timer interval expires.
C. The standby ASA runs network activity tests, including ARP and ping, to determine if the active ASA has failed.
D. The standby ASA sends additional hellos packets on all monitored interfaces, including the LAN failover interface, to determine if the active ASA has failed.
E. Both ASAs go to the “unknown” state until the LAN interface becomes operational again.
Correct Answer: D
QUESTION 73
Refer to the exhibit. The Cisco ASA is dropping all the traffic that is sourced from the internet and is destined to any security context inside interface. Which configuration should be verified on the Cisco ASA to solve this problem?
A. The Cisco ASA has NAT control disabled on each security context.
B. The Cisco ASA is using inside dynamic NAT on each security context.
C. The Cisco ASA is using a unique MAC address on each security context outside interface.
D. The Cisco ASA is using a unique dynamic routing protocol process on each security context.
E. The Cisco ASA packet classifier is configured to use the outside physical interface to assign the packets to each security context.
Correct Answer: C
QUESTION 74
Refer to the exhibit. The Cisco ASA is operating in transparent mode. What is required on the Cisco ASA so that R1 and R2 can form OSPF neighbor adjacency?
A. Map the R1 and R2 MAC address in the Cisco ASA MAC address table using the mac-address-table static if_name MAC_address command.
B. Configure OSPF stateful packet inspection using MPF.
C. Apply an EtherType ACL to the inside and outside interfaces to permit OSPF multicast traffic.
D. Apply an extended ACL to the inside and outside interfaces to permit OSPF multicast traffic.
E. Enable Advanced Application Inspection using MPF.
Correct Answer: D
QUESTION 75
On the Cisco ASA, where are the Layer 5-7 policy maps applied?
A. inside the Layer 3-4 policy map
B. inside the Layer 3-4 class map
C. inside the Layer 5-7 class map
D. inside the Layer 3-4 service policy
E. inside the Layer 5-7 service policy
Correct Answer: A
QUESTION 76
A Cisco ASA requires an additional feature license to enable which feature?
A. transparent firewall
B. cut-thru proxy
C. threat detection
D. botnet traffic filtering
E. TCP normalizer
Correct Answer: D
QUESTION 77
With Cisco ASA active/standby failover, what is needed to enable sub-second failover?
A. Use redundant interfaces.
B. Enable the stateful failover interface between the primary and secondary Cisco ASA.
C. Decrease the default unit failover polltime to 300 msec and the unit failover holdtime to 900 msec.
D. Decrease the default number of monitored interfaces to 1.
Correct Answer: C
QUESTION 78
Refer to the exhibit. Which command options represent the inside local address, inside global address, outside local address, and outside global address?
A. 1 = outside local, 2 = outside global, 3 = inside global, 4 = inside local
B. 1 = outside local, 2 = outside global, 3 = inside local, 4 = inside global
C. 1 = outside global, 2 = outside local, 3 = inside global, 4 = inside local
D. 1 = inside local, 2 = inside global, 3 = outside global, 4 = outside local
E. 1 = inside local, 2 = inside global, 3 = outside local, 4 = outside global
Correct Answer: D
QUESTION 79
On Cisco ASA Software Version 8.4.1 and later, when you configure the Cisco ASA appliance in transparent firewall mode, which configuration is mandatory?
A. NAT
B. static routes
C. ARP inspections
D. EtherType access-list
E. bridge group(s)
F. dynamic MAC address learning
Correct Answer: E
QUESTION 80
Which access rule is disabled automatically after the global access list has been defined and applied?
A. the implicit global deny ip any any access rule
B. the implicit interface access rule that permits all IP traffic from high security level to low security level interfaces
C. the implicit global access rule that permits all IP traffic from high security level to low security level interfaces
D. the implicit deny ip any any rule on the global and interface access lists
E. the implicit permit all IP traffic from high security level to low security level access rule on the global and interface access lists
Correct Answer: B
Free VCE & PDF File for Cisco 642-618 Real Exam
Instant Access to Free VCE Files: CCNA | CCNP | CCIE …
Instant Access to Free PDF Files: CCNA | CCNP | CCIE …
100-105 Dumps VCE PDF
200-105 Dumps VCE PDF
300-101 Dumps VCE PDF
300-115 Dumps VCE PDF
300-135 Dumps VCE PDF
300-320 Dumps VCE PDF
400-101 Dumps VCE PDF
640-911 Dumps VCE PDF
640-916 Dumps VCE PDF
70-410 Dumps VCE PDF
70-411 Dumps VCE PDF
70-412 Dumps VCE PDF
70-413 Dumps VCE PDF
70-414 Dumps VCE PDF
70-417 Dumps VCE PDF
70-461 Dumps VCE PDF
70-462 Dumps VCE PDF
70-463 Dumps VCE PDF
70-464 Dumps VCE PDF
70-465 Dumps VCE PDF
70-480 Dumps VCE PDF
70-483 Dumps VCE PDF
70-486 Dumps VCE PDF
70-487 Dumps VCE PDF
220-901 Dumps VCE PDF
220-902 Dumps VCE PDF
N10-006 Dumps VCE PDF
SY0-401 Dumps VCE PDF