Download New Updated (Spring 2015) Cisco 350-001 Actual Tests 141-150

Ensurepass

 

QUESTION 141

Refer to the exhibit. Router RTB is performing one-way redistribution from RIP to OSPF. Which outgoing interface will router RTD choose for packets to the 192.168.0.0/24 network, and why?

 

clip_image001

 

A.       Fa0/1, because OSPF is a link-state routing protocol

B.       Fa0/0, because RIP is a distance vector protocol

C.       Fa0/0, because RIP has a higher administrative distance

D.      Fa0/0, because OSPF has a lower administrative distance

E.       Fa0/1, because OSPF has a lower administrative distance

F.        Fa0/1, because RIP has a lower administrative distance

Correct Answer: E

 

 

QUESTION 142

Refer to the exhibit. R4 is unable to establish an EIGRP adjacency with R3, the only other router on the Fa0/0 LAN segment, although it is able to ping R3. An EIGRP debug on R4 does not provide any clues. What might be the cause of the problem?

 

clip_image003

 

A.       The passive interface has disabled the transmission of EIGRP multicast hello packets.

B.       EIGRP on R4 should be routing to network 209.165.202.128/28.

C.       The designated router/backup designated router (DR/BDR) selection requires that at least three routers are on a LAN.

D.      The routing metrics on R4 and R3 are different.

 

Correct Answer: A

 

 

QUESTION 143

Refer to the exhibit. The static route to 150.189.131.6 on R3 is intended to serve as the gateway of last resort for the EIGRP network. However, while R3 installs the gateway of last resort, its EIGRP neighbor R4 does not. What might explain the problem?

 

clip_image005

 

A.       R3 is missing the global command ip default-network 150.189.131.6.

B.       Autosummary must be enabled on R3 in order for default-routes to be propagated.

C.       Default-networks must be configured individually on each EIGRP router.

D.      The static route on R3 must be redistributed into EIGRP.

 

Correct Answer: D

 

 

QUESTION 144

Refer to the exhibit. Which statement would explain why R4 and R3 are unable to build an EIGRP adjacency?

 

clip_image007

 

A.        The network masks on R4 (209.165.202.128/27) and R3 (209.165.202.128/28) are different.

B.        The local EIGRP process on R4 and R3 are the same (but they must be unique).

C.        The routing metrics on R4 and R3 are different.

D.        R4 is not routing for the network 209.165.200.224/28.

 

Correct Answer: C

 

 

QUESTION 145

You are the network administrator of a Layer 3 switched network. Users in one VLAN are complaining that access to the server VLAN is very slow from time to time. Traffic in the local VLAN works without any issue, and users in other VLANs do not have any complaint to reach the server VLAN. What is most likely the cause of this issue?

 

A.       routing issue

B.       denial-of-service attack

C.       MAC flooding

D.      spanning-tree recalculation

E.       Layer 2 loop

F.        ARP spoofing attack

 

Correct Answer: F

 

 

QUESTION 146

You are the network administrator of an enterprise company that just deployed a global IP telephony environment. In order to guarantee good voice quality, you asked your provider to implement QoS on the CE routers of your MPLS network. On your LAN, you have also deployed QoS. Users, however, keep complaining about bad voice quality, and the provider does not see matches on the DSCP values that you have asked him to match upon. What is most likely the problem?

 

A.       The phones are not sending traffic with the correct DSCP value.

B.       The Cisco CallManager is not marking the traffic correctly.

C.       This is most likely a bug on the CE routers.

D.      Your LAN QoS is incorrectly configured.

 

Correct Answer: D

 

 

 

 

 

 

QUESTION 147

Refer to the exhibit. As soon as the OSPF neighbors are established across the GRE tunnel between RTA and RTC, the GRE tunnel immediately goes down/down. What could be a possible cause?

 

clip_image009

 

A.       The route to the tunnel destination is preferred via the tunnel.

B.       Autosummary is not configured.

C.       GRE tunnels cannot be in area 0.

D.      A misconfigured access list is on the router C tunnel interface.

E.       A misconfigured access list is on the router A tunnel interface.

 

Correct Answer: A

 

 

QUESTION 148

Which configuration would make an IP SLA probe use a precedence value of 5?

 

A.        ip sla 1

icmp-echo 1.1.1.1 tos 160

 

B.        ip sla 1

icmp-echo 1.1.1.1 tos 20

 

C.        ip sla 1

icmp-echo 1.1.1.1 precedence 5

 

D.        ip sla 1

icmp-echo 1.1.1.1 dscp 20

 

Correct Answer: A

 

 

QUESTION 149

Refer to the exhibit. When would the EEM applet be triggered?

 

clip_image011

 

A.       every time that the input errors counter is higher than 100

B.       every time that the input errors counter is slower than 10 errors per 10 seconds

C.       every time that the input errors counter is lower than 100

D.       every time that the input errors counter is faster than 100 errors per 10 seconds

 

Correct Answer: A

 

 

QUESTION 150

Refer to the exhibit. When would the EEM applet be triggered?

 

clip_image012

 

A.       once a month

B.       once a day

C.       once an hour

D.      once a minute

 

Correct Answer: C

 

Free VCE & PDF File for Cisco 350-001 Real Exam

Instant Access to Free VCE Files: CCNA | CCNP | CCIE …
Instant Access to Free PDF Files: CCNA | CCNP | CCIE …