Download New Updated (Spring 2015) Cisco 200-120 Actual Tests 71-80

Ensurepass

 

QUESTION 71

Which three of these statements regarding 802.1Q trunking are correct? (Choose three.)

 

A.      802.1Q native VLAN frames are untagged by default.

B.      802.1Q trunking ports can also be secure ports.

C.      802.1Q trunks can use 10 Mb/s Ethernet interfaces.

D.      802.1Q trunks require full-duplex, point-to-point connectivity.

E.       802.1Q trunks should have native VLANs that are the same at both ends.

 

Correct Answer: ACE

QUESTION 72

Refer to the exhibit. The output that is shown is generated at a switch. Which three statements are true? (Choose three.)

 

clip_image002

 

A.      All ports will be in a state of discarding, learning, or forwarding.

B.      Thirty VLANs have been configured on this switch.

C.      The bridge priority is lower than the default value for spanning tree.

D.      All interfaces that are shown are on shared media.

E.       All designated ports are in a forwarding state.

F.       This switch must be the root bridge for all VLANs on this switch.

 

Correct Answer: ACE

 

 

QUESTION 73

Which term describes a spanning-tree network that has all switch ports in either the blocking or forwarding state?

 

A.      converged

B.      redundant

C.      provisioned

D.      spanned

 

Correct Answer: A

 

 

 

QUESTION 74

Refer to the exhibit. At the end of an RSTP election process, which access layer switch port will assume the discarding role?

 

clip_image004

 

A.      Switch3, port fa0/1

B.      Switch3, port fa0/12

C.      Switch4, port fa0/11

D.      Switch4, port fa0/2

E.       Switch3, port Gi0/1

F.       Switch3, port Gi0/2

 

Correct Answer: C

 

 

QUESTION 75

What are the possible trunking modes for a switch port? (Choose three.)

 

A.      transparent

B.      auto

C.      on

D.      desirable

E.       client

F.       forwarding

 

Correct Answer: BCD

 

 

 

 

 

QUESTION 76

Which two of these statements regarding RSTP are correct? (Choose two.)

 

A.      RSTP cannot operate with PVST+.

B.      RSTP defines new port roles.

C.      RSTP defines no new port states.

D.      RSTP is a proprietary implementation of IEEE 802.1D STP.

E.       RSTP is compatible with the original IEEE 802.1D STP.

 

Correct Answer: BE

 

 

QUESTION 77

Refer to the exhibit. Which two statements are true of the interfaces on Switch1? (Choose two.)

 

clip_image006

 

A.      Multiple devices are connected directly to FastEthernet0/1.

B.      A hub is connected directly to FastEthernet0/5.

C.      FastEthernet0/1 is connected to a host with multiple network interface cards.

D.      FastEthernet0/5 has statically assigned MAC addresses.

E.       FastEthernet0/1 is configured as a trunk link.

F.       Interface FastEthernet0/2 has been disabled.

 

Correct Answer: BE

 

 

QUESTION 78

Three switches are connected to one another via trunk ports. Assuming the default switch configuration, which switch is elected as the root bridge for the spanning-tree instance of VLAN 1?

 

A.      the switch with the highest MAC address

B.      the switch with the lowest MAC address

C.      the switch with the highest IP address

D.      the switch with the lowest IP address

 

Correct Answer: B

 

 

QUESTION 79

What are three advantages of VLANs? (Choose three.)

 

A.      VLANs establish broadcast domains in switched networks.

B.      VLANs utilize packet filtering to enhance network security.

C.      VLANs provide a method of conserving IP addresses in large networks.

D.      VLANs provide a low-latency internetworking alternative to routed networks.

E.       VLANs allow access to network services based on department, not physical location.

F.       VLANs can greatly simplify adding, moving, or changing hosts on the network.

 

Correct Answer: AEF

 

 

QUESTION 80

Cisco Catalyst switches CAT1 and CAT2 have a connection between them using ports FA0/13. An

802.1Q trunk is configured between the two switches. On CAT1, VLAN 10 is chosen as native, but on CAT2 the native VLAN is not specified. What will happen in this scenario?

 

A.      802.1Q giants frames could saturate the link.

B.      VLAN 10 on CAT1 and VLAN 1 on CAT2 will send untagged frames.

C.      A native VLAN mismatch error message will appear.

D.      VLAN 10 on CAT1 and VLAN 1 on CAT2 will send tagged frames.

 

Correct Answer: C

 

Free VCE & PDF File for Cisco 200-120 Real Exam

Instant Access to Free VCE Files: CCNA | CCNP | CCIE …
Instant Access to Free PDF Files: CCNA | CCNP | CCIE …