Download New Updated (Spring 2015) Cisco 100-101 Actual Tests 91-100

Ensurepass

 

QUESTION 91

Refer to the exhibit. The junior network support staff provided the diagram as a recommended configuration for the first phase of a four-phase network expansion project. The entire network expansion will have over 1000 users on 14 network segments and has been allocated this IP address space.

 

192.168.1.1 through 192.168.5.255

192.168.100.1 through 192.168.100.255

 

What are three problems with this design? (Choose three.)

 

clip_image002

 

A.      The AREA 1 IP address space is inadequate for the number of users.

B.      The AREA 3 IP address space is inadequate for the number of users.

C.      AREA 2 could use a mask of /25 to conserve IP address space.

D.      The network address space that is provided requires a single network-wide mask.

E.       The router-to-router connection is wasting address space.

F.       The broadcast domain in AREA 1 is too large for IP to function.

 

Correct Answer: ACE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

QUESTION 92

Refer to the exhibit. Host A can communicate with Host B but not with Hosts C or D. How can the network administrator solve this problem?

 

clip_image004

 

A.      Configure Hosts C and D with IP addresses in the 192.168
.2.0 network.

B.      Install a router and configure a route to route between VLANs 2 and 3.

C.      Install a second switch and put Hosts C and D on that switch while Hosts A and B remain on the original switch.

D.      Enable the VLAN trunking protocol on the switch.

 

Correct Answer: B

 

 

QUESTION 93

Refer to the exhibit. A network administrator has configured a Catalyst 2950 switch for remote management by pasting into the console the configuration commands that are shown in the exhibit. However, a Telnet session cannot be successfully established from a remote host. What should be done to fix this problem?

 

clip_image006

 

A.      Change the first line to interface fastethernet 0/1.

B.      Change the first line to interface vlan 0/1.

C.      Change the fifth line t
o ip default-gateway 192.168.17.241.

D.      Change the fifth line to ip route 0.0.0.0 0.0.0.0 192.168.17.1.

E.       Change the sixth line to line con 0.

 

Correct Answer: C

 

 

QUESTION 94

Refer to the exhibit. The network administrator is testing connectivity from the branch router to the newly installed application server. What is the most likely reason for the first ping having a success rate of only 60 percent?

 

clip_image008

 

A.      The network is likely to be congested, with the result that packets are being intermittently dropped.

B.      The branch router had to resolve the application server MAC address.

C.      There is a short delay while NAT translates the server IP address.

D.      A routing table lookup delayed forwarding on the first two ping packets
.

E.       The branch router LAN interface should be upgraded to FastEthernet.

 

Correct Answer: B

 

 

 

 

 

 

 

 

 

 

 

 

QUESTION 95

clip_image010

clip_image012

 

Select two options which are security Issues which need to be modified before RouterA is used? (Choose two.)

 

A.      unencrypted weak password is configured to protect privilege mode

B.      inappropriate wording in banner message

C.      the virtual terminal lines have a weak password configured

D.      virtual terminal lines have a password, but it will not be used

E.       configuration supports un-secure web server access

 

Correct Answer: BD

 

 

 

QUESTION 96

clip_image014

clip_image016

 

Select three options which are security issues with the current configuration of SwitchA. (Choose three.)

 

A.      privilege mode is protected with an unencrypted password

B.      inappropriate wording in banner message

C.      virtual terminal lines are protected only by a password requirement

D.      both the username and password are weak

E.       telnet connections can be used to remotely manage the switch

F.       cisco user will be granted privilege level 15 by default

 

Correct Answer: ABD

 

 

QUESTION 97

clip_image018

clip_image020

 

Which two of the following are true regarding the configuration of RouterA? (Choose two.)

 

A.      at least 5 simultaneous remote connections are possible

B.      only telnet protocol connections to RouterA are supported

C.      remote connections to RouterA using telnet will succeed

D.      console line connections will nevertime out due to inactivity

E.       since DHCP is not used on Fa0/1 there is not a need to use the NAT protocol

 

Correct Answer: AC

 

 

 

 

QUESTION 98

clip_image010[1]

clip_image022

 

Which of the following is true regarding the
configuration of SwitchA?

 

A.      only 5 simultaneous remote connections are possible

B.      remote connections using ssh will require a username and password

C.      only connections from the local network will be possible

D.      console access to SwitchA requires a password

 

Correct Answer: B

 

 

 

 

 

QUESTION 99

clip_image024

clip_image026

clip_image028

 

What is the subnet broadcast address of the LAN connected to Router1?

 

A.      192.168.8.15

B.      192.168.8.31

C.      192.168.8.63

D.      192.168.8.127

 

Correct Answer: A

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

QUESTION 100

clip_image030

clip_image032

clip_image034

 

What is the bandwidth on the WAN interface of Router 1?

 

A.      16 Kbit/sec

B.      32 Kbit/sec

C.      64 Kbit/sec

D.      128 Kbit/sec

E.       512 Kbit/sec

F.       1544 Kbit/sec

 

Correct Answer: A

 

Free VCE & PDF File for Cisco 100-101 Real Exam

Instant Access to Free VCE Files: CCNA | CCNP | CCIE …
Instant Access to Free PDF Files: CCNA | CCNP | CCIE …