Category: 642-902 DUMPS

Ensurepass QUESTION  341 Which three steps are most helpful in verifying proper route redistribution? (Choose three.)   A.       On the routers not performing the route redistribution, use the show ip route command to see if the redistributed routes show up. Read More …

Ensurepass QUESTION  331 A network administrator would like to configure an EIGRP router as a stub router that advertises directly connected and summary routes only. What command must the administrator issue to accomplish this?   A.       eigrp stub B.       eigrp Read More …

Ensurepass QUESTION  321 What two features are benefits of using GRE tunnels with IPsec over using IPsec tunnel alone for building site-to-site VPNs? (Choose two.)   A.       allows dynamic routing securely over the tunnel B.       IKE keepalives are unidirectional and Read More …

Ensurepass QUESTION  311 Refer to the exhibit. ROUTE.com is planning to implement load balancing for traffic between hosts on the 172.16.10.0/24 and 172.16.20./24 networks. You have been asked to review the implementation plan for this project. Which statement about the Read More …

Ensurepass QUESTION  301 In EIGRP, when the IP default-network command is configured on a router, what is generated in the router’s configuration?   A.       A static route B.       A directly connected route C.       An EIGRP route D.      A default route Read More …

Ensurepass QUESTION  291 Refer to the Exhibit. Routers in the Diagram are configured with EIGRP. If RTB and RTC fail, which action will RTA take with respect to the HQ network?     A.       RTA will automatically route packets via Read More …

Ensurepass QUESTION  281 Click and drag the associated EIGRP functionality on the left to the corresponding topology characteristic on the right.     Correct Answer:     QUESTION  282 Which two statements about 6to4 tunneling are accurate? (Choose two.)   Read More …

Ensurepass QUESTION  271 When policy-based routing (PBR) is being configured, which three criteria can the set command specify? (Choose three.)   A.  all interfaces through which the packets can be routed B.  all interfaces in the path toward the destination Read More …

Ensurepass QUESTION  261 An IPv6 overlay tunnel is required to communicate with isolated IPv6 networks across an IPv4 infrastructure. There are currently five IPv6 overlay tunnel types. Which three IPv6 overlay tunnel statements are true? (Choose three.)   A.       Overlay Read More …

Ensurepass QUESTION  251 Refer to the exhibit. Which two statements are correct regarding the routes to be redistributed into OSPF? (Choose two.)     A.  The network 192.168.1.0 will be allowed and assigned a metric of 100. B.  The network Read More …

Ensurepass QUESTION  241 Which statement describes the difference between a manually configured IPv6 in IPv4 tunnel versus an automatic 6to4 tunnel?   A.       A manually configured IPv6 in IPv4 tunnel allows multiple IPv4 destinations. B.       An automatic 6to4 tunnel allows Read More …

Ensurepass QUESTION  231 To enable BGP tunneling over an IPv4 backbone, the IPv4 address 192.168.30.1 is converted into a valid IPv6 address. Which three IPv6 addresses are acceptable formats for the IPv4 address? (Choose three.)   A.       192.168.30.1:0:0:0:0:0:0 B.       0:0:0:0:0:0:192.168.30.1 Read More …

Ensurepass QUESTION  221 When an IPv6 enabled host boots, it sends a router solicitation (RS) message. An IPv6 router responds with a router advertisement (RA). Which two items are contained in the RA? (Choose two.)   A.       IPv6 address for Read More …

Ensurepass QUESTION  211 What happens when an IPv6 enabled router running 6to4 must send a packet to a remote destination and the next hop is the address of 2002::/16?   A.       The IPv6 packet has its header removed and replaced Read More …

Ensurepass QUESTION  201 What technique should be used on BGP edge routers to prevent a multi-homed autonomous system from becoming a transit system?   A.      Advertise with a high MED value all networks that are discovered via external BGP. B.      Read More …

Ensurepass QUESTION  191 Which two statements are true about IBGP neighbor relationships? (Choose two.)   A.       An EGP or static routing is required between IBGP neighbors. B.       A full-mesh IBGP requires that neighbor relationships be established between all BGP enabled Read More …

Ensurepass QUESTION  181 Above is the output from show ip bgp neighbors command. What is line 21 stating about the BGP connection?     A.       the number of neighbors that the router has B.       the number of times the router Read More …

Ensurepass QUESTION  171 Refer to the exhibit. Router RT-1 chooses one path to network 198.133.219.0/24. Indicate the reason Router RT-1 chooses this "best" path.     A.       In making its decision about the best path, RT-1 gives precedence to the Read More …