New Updated Cisco ICND1 100-101 Real Exam Download 311-320

Ensurepass QUESTION 311 Refer to the exhibit. The network shown in the diagram is experiencing connectivity problems. Which of the following will correct the problems? (Choose two.)     A.        Configure the gateway on Host A as 10.1.1.1. B.        Configure the gateway on Host B as 10.1.2.254. C.        Configure the IP address of Host A as 10.1.2.2. D.        Read more [...]

New Updated Cisco ICND1 100-101 Real Exam Download 301-310

EnsurepassQUESTION 301 Which VTP mode is capable of creating only local VLANs and does not synchronize with other switches in the VTP domain?   A.       client B.       dynamic C.       server D.       static E.        transparent   Correct Answer: E     QUESTION 302 A switch is configured with all ports assigned to vlan 2 with Read more [...]

New Updated Cisco ICND1 100-101 Real Exam Download 291-300

Ensurepass QUESTION 291 A network administrator is explaining VTP configuration to a new technician. What should the network administrator tell the new technician about VTP configuration? (Choose three.)   A.       A switch in the VTP client mode cannot update its local VLAN database. B.       A trunk link must be configured between the switches to forward VTP updates. C.       A switch in the VTP server Read more [...]

New Updated Cisco ICND1 100-101 Real Exam Download 281-290

Ensurepass QUESTION 281 At which layer of the OSI model is RSTP used to prevent loops?   A.        data link B.        network C.        physical D.        transport   Correct Answer: A     QUESTION 282 Refer to the exhibit. A system administrator installed a new switch using a script to configure it. IP connectivity was tested using pings Read more [...]

New Updated Cisco ICND1 100-101 Real Exam Download 271-280

EnsurepassQUESTION 271 Which IEEE standard protocol is initiated as a result of successful DTP completion in a switch over FastEthernet?   A.       802.3ad B.       802.1w C.       802.1Q D.       802.1d   Correct Answer: C     QUESTION 272 Which command enhances the 802.1D convergence time on ports that are connected to hosts?   A.       Read more [...]

New Updated Cisco ICND1 100-101 Real Exam Download 261-270

Ensurepass QUESTION 261 Refer to the exhibit. The output that is shown is generated at a switch. Which three of these statements are true? (Choose three.)     A.       All ports will be in a state of discarding, learning or forwarding. B.       Thirty VLANs have been configured on this switch. C.       The bridge priority is lower than the default value for spanning tree. D.       Read more [...]

New Updated Cisco ICND1 100-101 Real Exam Download 251-260

EnsurepassQUESTION 251 A Catalyst 2950 needs to be reconfigured. What steps will ensure that the old configuration is erased? (Choose three.)   A.        Erase flash. B.        Restart the switch. C.        Delete the VLAN database. D.        Erase the running configuration. E.         Erase the startup configuration. Read more [...]

New Updated Cisco ICND1 100-101 Real Exam Download 241-250

EnsurepassQUESTION 241 Which switch would STP choose to become the root bridge in the selection process?   A.        32768: 11-22-33-44-55-66 B.        32768: 22-33-44-55-66-77 C.        32769: 11-22-33-44-55-65 D.        32769: 22-33-44-55-66-78   Correct Answer: A     QUESTION 242 A company implements video conferencing over IP on their Read more [...]

New Updated Cisco ICND1 100-101 Real Exam Download 231-240

Ensurepass QUESTION 231 A network administrator is troubleshooting the OSPF configuration of routers R1 and R2. The routers cannot establish an adjacency relationship on their common Ethernet link. The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2. Based on the information in the graphic, what is the cause of this problem?     A.        The OSPF area is not configured properly. B.        Read more [...]

New Updated Cisco ICND1 100-101 Real Exam Download 221-230

EnsurepassQUESTION 221 Which commands are required to properly configure a router to run OSPF and to add network 192.168.16.0/24 to OSPF area 0? (Choose two)   A.        Router(config)#router ospf 1 B.        Router(config)#router ospf 0 C.        Router(config)#router ospf area 0 D.        Router(config-router)#network 192.168.16.0 0.0.0.255 area 0 E.         Read more [...]

New Updated Cisco ICND1 100-101 Real Exam Download 211-220

EnsurepassQUESTION 211 A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782. The last is from RIPv2 and has a metric of 4. Which route or routes will the router install in the routing table?   A.       the OSPF route B.       the EIGRP route C.       the Read more [...]

New Updated Cisco ICND1 100-101 Real Exam Download 201-210

EnsurepassQUESTION 201 OSPF routing uses the concept of areas. What are the characteristics of OSPF areas? (Choose three.)   A.       Each OSPF area requires a loopback interface to be configured. B.       Areas may be assigned any number from 0 to 65535. C.       Area 0 is called the backbone area. D.       Hierarchical OSPF networks do not require multiple areas. E.        Read more [...]

New Updated Cisco ICND1 100-101 Real Exam Download 191-200

Ensurepass QUESTION 191 Which of the following are true regarding the debug output shown in the graphic? (Choose Two)     A.     This router was configured with the commands: RtrA(config)#router rip RtrA(config-router)#version 2 RtrA(config-router)#network 172.16.0.0 RtrA(config-router)#network 10.0.0.0   B.     This router was configured with the commands: RtrA(config)#router rip RtrA(config-router)#network 172.16.0.0 RtrA(config-router)#network Read more [...]

New Updated Cisco ICND1 100-101 Real Exam Download 171-180

EnsurepassQUESTION 171 Use the output from the router shown in the graphic above to determine which of the following are correct. (Choose two.)     A.        Router John uses a link-state routing protocol. B.        Router John will receive routing updates on the Serial0/0 interface. C.        Router John will receive routing updates on the Serial0/1 interface. D.        Read more [...]

New Updated Cisco ICND1 100-101 Real Exam Download 141-150

EnsurepassQUESTION 151 In the implementation of VLSM techniques on a network using a single Class C IP address, which subnet mask is the most efficient for point-to-point serial links?   A.        255.255.255.240 B.        255.255.255.254 C.        255.255.255.252 D.        255.255.255.0 E.         255.255.255.248 Read more [...]

New Updated Cisco ICND1 100-101 Real Exam Download 131-140

EnsurepassQUESTION 131 Which of the following host addresses are members of networks that can be routed across the public Internet? (Choose Three.)   A.        10.172.13.65 B.        172.16.223.125 C.        172.64.12.29 D.        192.168.23.252 E.         198.234.12.95 F.         Read more [...]

New Updated Cisco ICND1 100-101 Real Exam Download 121-130

EnsurepassQUESTION 121 The ip subnet zero command is not configured on a router. What would be the IP address of Ethernet0/0 using the first available address from the sixth subnet of the network 192.168.8.0/29?   A.        192.168.8.25 B.        192.168.8.41 C.        192.168.8.49 D.        192.168.8.113   Correct Answer: C     QUESTION 122 Read more [...]

New Updated Cisco ICND1 100-101 Real Exam Download 111-120

EnsurepassQUESTION 111 Refer to the exhibit. Which three statements correctly describe Network Device A? (Choose three.)     A.       With a network wide mask of 255.255.255.128, each interface does not require an IP address. B.       With a network wide mask of 255.255.255.128, each interface does require an IP address on a unique IP subnet. C.       With a network wide mask of 255.255.255.0, must Read more [...]