New Updated CCIE Data Center 350-080 Real Exam Download 61-70

EnsurepassQUESTION 61 Which three statements best describe multicast operation on Cisco Nexus switches in a data center? (Choose three.)   A.      Cisco NX-OS Software does not support PIM dense mode. B.      The command ip multicast-routing must be enabled in Cisco NX-OS Software before any multicast configuration is possible on the switch. C.      PIM CLI configuration and verification commands are not available until you enable the PIM feature with the feature pim command. D.      Read more [...]

New Updated CCIE Data Center 350-080 Real Exam Download 51-60

EnsurepassQUESTION 51 Which statement describes the XML management interface in Cisco NX-OS Software?   A.      The following XML-based NETCONF operations are supported in NX-OS Software. Close session, copy-config, delete-config, and edit-config. B.      The following XML-based NETCONF operations are supported in NX-OS Software. Close session, copy-config, edit-config, and kill-session. C.      NX-OS Software supports up to a maximum of 16 concurrent XML sessions. D.      Only Read more [...]

New Updated CCIE Data Center 350-080 Real Exam Download 41-50

EnsurepassQUESTION 41 What is the benefit of using Anycast RP via RFC 4610 for IP multicast RP redundancy?   A.      Improves convergence of the multicast network due to enhanced RPF checks B.      Simplifies the number of control plane protocols over other RP redundancy methods C.      Eliminates the use of Protocol Independent Multicast (PIM) in the topology D.      Increases the administrative distances in Multicast Source Discovery Protocol (MSDP) Configuration   Correct Read more [...]

New Updated CCIE Data Center 350-080 Real Exam Download 31-40

EnsurepassQUESTION 31 After configuring FabricPath, the following appears in the syslog:   %STP-2-L2GW_BACKBONE_BLOCK: L2 Gateway Backbone port inconsistency blocking port port-channel 100 on VLAN0010.   What is the cause of this message?   A.      STP must be disabled; message indicates that STP is enabled. B.      STP is misconfigured; root guard must be disabled. C.      An inferior BPDU is received on a Cisco FabricPath edge port. D.      A superior BPDU is received on Read more [...]

New Updated CCIE Data Center 350-080 Real Exam Download 21-30

EnsurepassQUESTION 21 The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer link. Which statements are true about the vPC peer-gateway? (Choose two.)   A.      The vPC peer-gateway feature is enabled by default. B.      The vPC peer-gateway feature can be configured globally under the vPC domain Read more [...]

New Updated CCIE Data Center 350-080 Real Exam Download 11-20

EnsurepassQUESTION 11 Which three flow-control port states lead to enabled link flow control? (Choose three.)   A.      Receive port: Enabled, Transmit port: Enabled B.      Receive port: Enabled, Transmit port: Desired C.      Receive port: Enabled, Transmit port: Disabled D.      Receive port: Disabled, Transmit port: Desired E.       Receive port: Desired, Transmit port: Desired   Correct Answer: ABE     QUESTION 12 In a configuration with redundant supervisors, how Read more [...]

New Updated Cisco CCNA Video 200-001 Real Exam Download 61-70

EnsurepassQUESTION 61 Which Cisco TelePresence endpoint uses only Cisco Unified Communications Manager as its call control device?   A.      SX20 B.      Cisco TelePresence System 500-32 C.      EX90 D.      C60 E.       Video Communication Server Correct Answer: B QUESTION 62 When manual discovery is used to register a Cisco TelePresence endpoint to a VCS Read more [...]