Latest CCNA 220-120 Real Exam Download 221-230

EnsurepassQUESTION 221 Refer to the exhibit. Hosts in network 192.168.2.0 are unable to reach hosts in network 192.168.3.0. Based on the output from RouterA, what are two possible reasons for the failure? (Choose two.)   A.      The cable that is connected to S0/0 on RouterA is faulty. B.      Interface S0/0 on RouterB is administratively down. C.      Interface S0/0 on RouterA is configured with an incorrect subnet Read more [...]

Latest CCNA 220-120 Real Exam Download 211-220

EnsurepassQUESTION 211 Which statement about access lists that are applied to an interface is true?   A.      You can place as many access lists as you want on any interface. B.      You can apply only one access list on any interface. C.      You can configure one access list, per direction, per Layer 3 protocol. D.      You can apply multiple access lists with the same protocol or in different Read more [...]

Latest CCNA 220-120 Real Exam Download 201-210

EnsurepassQUESTION 201 Drag and drop.   Correct Answer:     QUESTION 202 Refer to the exhibit. A junior network administrator was given the task of configuring port security on SwitchA to allow only PC_A to access the switched network through port fa0/1. If any other device is detected, the port is to drop frames from this device. The administrator configured the interface and tested it with successful pings from PC_A to RouterA, and then observes the output from these two Read more [...]

Latest CCNA 220-120 Real Exam Download 191-200

EnsurepassQUESTION 191 What are two benefits of using NAT? (Choose two.)   A.      NAT facilitates end-to-end communication when IPsec is enabled. B.      NAT eliminates the need to re-address all hosts that require external access. C.      NAT conserves addresses through host MAC-level multiplexing. D.      Dynamic NAT facilitates connections from the outside of the network. E.       Read more [...]

Latest CCNA 220-120 Real Exam Download 161-170

EnsurepassQUESTION 161 Refer to the exhibit. A network administrator configures a new router and enters the copy startup-config running-config command on the router. The network administrator powers down the router and sets it up at a remote location. When the router starts, it enters the system configuration dialog as shown. What is the cause of the problem?     A.      The network administrator failed to save the configuration. B.      Read more [...]

Latest CCNA 220-120 Real Exam Download 151-160

EnsurepassQUESTION 151 If IP routing is enabled, which two commands set the gateway of last resort to the default gateway? (Choose two.)   A.      ip default-gateway 0.0.0.0 B.      ip route 172.16.2.1 0.0.0.0 0.0.0.0 C.      ip default-network 0.0.0.0 D.      ip default-route 0.0.0.0 0.0.0.0 172.16.2.1 E.       ip route 0.0.0.0 0.0.0.0 172.16.2.1   Read more [...]

Latest CCNA 220-120 Real Exam Download 141-150

EnsurepassQUESTION 141 What is a global command?   A.      a command that is set once and affects the entire router B.      a command that is implemented in all foreign and domestic IOS versions C.      a command that is universal in application and supports all protocols D.      a command that is available in every release of IOS, regardless of the version or deployment status E.       Read more [...]

Latest CCNA 220-120 Real Exam Download 131-140

EnsurepassQUESTION 131 Refer to the exhibit. The network administrator must establish a route by which London workstations can forward traffic to the Manchester workstations. What is the simplest way to accomplish this?     A.      Configure a dynamic routing protocol on London to advertise all routes to Manchester. B.      Configure a dynamic routing protocol on London to advertise summarized routes to Manchester. C.      Read more [...]

Latest CCNA 220-120 Real Exam Download 121-130

EnsurepassQUESTION 121 The network administrator is asked to configure 113 point-to-point links. Which IP addressing scheme defines the address range and subnet mask that meet the requirement and waste the fewest subnet and host addresses?   A.      10.10.0.0/16 subnetted with mask 255.255.255.252 B.      10.10.0.0/18 subnetted with mask 255.255.255.252 C.      10.10.1.0/24 subnetted with mask 255.255.255.252 D.      Read more [...]

Latest CCNA 220-120 Real Exam Download 101-110

EnsurepassQUESTION 101 What is the alternative notation for the IPv6 address B514:82C3:0000:0000:0029:EC7A:0000:EC72?   A.      B514 : 82C3 : 0029 : EC7A : EC72 B.      B514 : 82C3 :: 0029 : EC7A : EC72 C.      B514 : 82C3 : 0029 :: EC7A : 0000 : EC72 D.      B514 : 82C3 :: 0029 : EC7A : 0 : EC72   Correct Answer: D     QUESTION 102 Refer to the diagram. All hosts have Read more [...]

Latest CCNA 220-120 Real Exam Download 81-90

EnsurepassQUESTION 81 Refer to the exhibit. A network technician is asked to design a small network with redundancy. The exhibit represents this design, with all hosts configured in the same VLAN. What conclusions can be made about this design?     A.      This design will function as intended. B.      Spanning-tree will need to be used. C.      The router will not accept the addressing scheme. D.      Read more [...]

Latest CCNA 220-120 Real Exam Download 71-80

EnsurepassQUESTION 71 Which three of these statements regarding 802.1Q trunking are correct? (Choose three.)   A.      802.1Q native VLAN frames are untagged by default. B.      802.1Q trunking ports can also be secure ports. C.      802.1Q trunks can use 10 Mb/s Ethernet interfaces. D.      802.1Q trunks require full-duplex, point-to-point connectivity. E.       Read more [...]

Latest CCNA 220-120 Real Exam Download 61-70

EnsurepassQUESTION 61 Which command can be used from a PC to verify the connectivity between hosts that connect through a switch in the same LAN?   A.      pingaddress B.      tracertaddress C.      tracerouteaddress D.      arpaddress   Correct Answer: A     QUESTION 62 Based on the network shown in the graphic. Which option contains both the potential networking problem Read more [...]

Latest CCNA 220-120 Real Exam Download 51-60

EnsurepassQUESTION 51 Assuming the default switch configuration, which VLAN range can be added, modified, and removed on a Cisco switch? A.      1 through 1001 B.      2 through 1001 C.      1 through 1002 D.      2 through 1005   Correct Answer: B     QUESTION 52 Which statement about VLAN operation on Cisco Catalyst switches is true?   A.      Read more [...]