2013 Latest ADVDESIGN CCDE 352-001 exam 241-245


MPLS TE tunnel is created on a PE-router and terminates at another PE-router. Study the exhibit carefully. A service provider with a multi-area OSPF environment would like to set up Cisco MPLS TE tunnels among provider edge routers across area boundaries. The LSPs
are configured with bandwidth constraints and explicit loose route hops as indicated by the arrows in the following path:
PE1 -> ABR1 -> ABR2 -> PE2
The network has enough resources to set up the Cisco MPLS TE tunnel from PE1 to PE2. For which devices will PE1 run CSPF?
A. all routers and links in Area 1 only
B. all routers and links in Area 1 and Area 2 only
C. all routers and links in Area 0, Area 1, and Area 2
D. all routers and links in Area 1 and Area 0 only
Correct Answer: A

A security analysis at The Potomac Canal Company recommends installing an IDS appliance and a firewall appliance. These appliances should connect directly into a Layer 3 switch. A load balancer and SSL termination have also been
recommended.Potomac’s management have expressed concern over the cost. You suggest using integrated blades. What is one
advantage and one disadvantage of your design proposal? (Choose two.)
A. The data center would need several devices to achieve its goal. B. Increased usage of standalone devices is cost-effective.
C. Using integrated blades would only require two devices.
D. Putting all security devices in a single chassis provides a single point of failure.
Correct Answer: CD

You are the Cisco Network Designer in P4S. Which two
statements about Layer 3 access designs are correct? (Choose two.)
A. Convergence time is fractionally slower than STP. B. Broadcast and fault domains are increased.
C. IP address space is difficult to manage.
D. Fast uplink convergence is supported for failover and fallback.
Correct Answer: CD

Which content networking device allows bandwidth configuration settings so that streaming content will not interfere with other network traffic?
A. IP/TV Control Server
B. Content Distribution Manager
C. Content Engine
D. IP/TV Broadcast Server
Correct Answer: A

The Internet Group Management Protocol (IGMP) is a
communications protocol used to manage the membership of Internet Protocol multicast groups. IGMP is used by IP hosts and adjacent multicast routers to establish multicast group memberships .What is the purpose of IGMP in a multicast implementation?
A. it is used in multicast
B. it is not used in multicast
C. it dynamically registers individual hosts in a multicast group on a specific LAN
D. it is used on WAN connections to determine the maximum bandwidth of a connection
Correct Answer: C

Ensurepass offers Latest 2013 352-001 Real Exam Questions, help you to pass exam 100%.