2013 Latest 642-832 Pass4sure Free Tests 21-30

Ensurepass

 

QUESTION 21

Refer to the exhibit.

clip_image002

clip_image004

clip_image006

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, and FHRP services, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.

 

Use the supported commands to isolated the cause of this fault and answer the following questions. What is the solution to the fault condition?

 

A.       In Configuration mode, using the interface port-channel 13 command, then configure switchport trunk allowed vlan none followed by switchport trunk allowed vlan 20,200 commands.

B.       In Configuration mode, using the interface port-channel 13, port-channel 23, then configure switchport trunk none allowed vlan none followed by switchport trunk allowed vlan 10,200 commands.

C.       In Configuration mode, using the interface port-channel 23 command, then configure switchport trunk allowed vlan none followed by switchport trunk allowed vlan 20,200 commands.

D.       In Configuration mode, using the interface port-channel 23, port-channel, then configure switchport trunk allowed vlan none followed by switchport trunk allowed vlan 10,20,200 commands.

 

Correct Answer: B

 

 

Ticket 2 : ACCESS VLAN

QUESTION 22

Refer to the exhibit.

clip_image007

clip_image008

clip_image006[1]

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.

 

Use the supported commands to isolated the cause of this fault and answer the following questions. What is the solution to the fault condition?

 

A.       R1

B.       R2

C.       R3

D.      R4

E.       DSW1

F.        DSW2

G.      ASW1

H.      ASW2

 

Correct Answer: G

 

 

QUESTION 23

Refer to the exhibit.

clip_image007[1]

clip_image009

clip_image010

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.

 

Use the supported commands to isolated the cause of this fault and answer the following questions. The fault condition is related to switch technology?

 

A.       NTP

B.       Switch-to-Switch Connectivity

C.       Loop Prevention

D.      Access Vlans

E.       VLAN ACL Port ACL

F.        Switch Virtual Interface

G.      Port Security

 

Correct Answer: D

 

 

QUESTION 24

Refer to the exhibit.

clip_image011

clip_image009[1]

clip_image010[1]

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.

 

Use the supported commands to isolated the cause of this fault and answer the following questions. What is the solution to the fault condition?

 

A.       In Configuration mode, using the interface range Fastethernet 1/0/1-2, then switchport mode access vlan 10 command.

B.       In Configuration mode, using the interface range Fastethernet 1/0/1-2, then switchport access mode vlan 10 command.

C.       In Configuration mode, using the interface range Fastethernet 1/0/1-2, then switchport vlan 10 access command.

D.       In Configuration mode, using the interface range Fastethernet 1/0/1-2, then switchport access vlan 10 command.

 

Correct Answer: D

 

 

 

 

Ticket 3 : OSPF Authentication

QUESTION 25

Refer to the exhibit.

clip_image011[1]

clip_image009[2]

clip_image010[2]

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.

 

Use the supported commands to isolated the cause of this fault and answer the following questions. On which device is the fault condition located?

 

A.       R1

B.       R2

C.       R3

D.      R4

E.       DSW1

F.        DSW2

G.      ASW1

H.      ASW2

 

Correct Answer: A

 

 

QUESTION 26

Refer to the exhibit.

clip_image011[2]

clip_image009[3]

clip_image010[3]

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.

 

Use the supported commands to isolated the cause of this fault and answer the following questions. The fault condition is related to which technology?

 

A.       BGP

B.       NTP

C.       IP NAT

D.      IPv4 OSPF Routing

E.       IPv4 OSPF Redistribution

F.        IPv6 OSPF Routing

G.      IPv4 layer 3 security

 

Correct Answer: D

 

 

QUESTION 27

Refer to the exhibit.

clip_image011[3]

clip_image009[4]

clip_image010[4]

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.

 

Use the supported commands to isolated the cause of this fault and answer the following questions. What is the solution to the fault condition?

 

A.        Enable OSPF authentication on the s0/0/0 interface using the ip ospf authentication message- digest command

B.        Enable OSPF routing on the s0/0/0 interface using the network 10.1.1.0 0.0.0.255 area 12 command.

C.        Enable OSPF routing on the s0/0/0 interface using the network 209.65.200.0 0.0.0.255 area 12 command.

D.        Redistribute the BGP route into OSPF using the redistribute BGP 65001 subnet command.

 

Correct Answer: A

 

 

Ticket 4 : BGP Neighbor

QUESTION 28

Refer to the exhibit.

clip_image011[4]

clip_image009[5]

clip_image010[5]

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing schemes, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.

 

Use the supported commands to isolated the cause of this fault and answer the following questions. On which device is the fault condition located?

 

A.       R1

B.       R2

C.       R3

D.      R4

E.       DSW1

F.        DSW2

G.      ASW1

 

Correct Answer: A

 

 

QUESTION 29

Refer to the exhibit.

clip_image011[5]

clip_image009[6]

clip_image010[6]

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.

 

Use the supported commands to isolated the cause of this fault and answer the following questions. The fault condition is related to which technology?

 

A.       BGP

B.       NTP

C.       IP NAT

D.      IPv4 OSPF Routing

E.       IPv4 OSPF Redistribution

F.        IPv6 OSPF Routing

G.      IPv4 layer 3 security

 

Correct Answer: A

 

 

QUESTION 30

Refer to the exhibit.

clip_image011[6]

clip_image009[7]

clip_image010[7]

The implementations group has been using the test bed to do a `proof-of-concept’ that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address.

 

Use the supported commands to isolated the cause of this fault and answer the following questions. What is the solution to the fault condition?

 

A.       Under the BGP process, enter the bgp redistribute-internal command.

B.       Under the BGP process, bgp confederation identifier 65001command.

C.       Deleted the current BGP process and reenter all of the command using 65002 as the AS number.

D.      Under the BGP process, delete the neighbor 209.56.200.226 remote-as 65002 command and enter the neighbor 209.65.200.226 remote-as 65002 command.

 

Correct Answer: D

 

DownloadLatest 2013 642-832 Free Tests , help you to pass exam 100%.

 

 

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.